Remove monolithic OpenFlow switch.
Add userspace datapath.
Fix BUG#13: Revise check wildcards for in_port != out_port output
validation.
Fix BUG#30: Made use of get_jiffies_64 instead of jiffies.
Fix BUG#31: Fix NetFPGA crash in case of test_delete test harness run.
Fix BUG#32: Add stack depth limitation to avoid inifinite loop in
log_backtrace.
Fix BUG#33: Improve NetFPGA kernel extension and NetFPGA image to
support MAC address rewrite features (two actions) on NetFPGA enabled
OpenFlow switch.
Fix BUG#34: Add NetFPGA kernel extension source codes to create
distribution package with NetFPGA correctly.
Fix BUG#38: Improve regression test for FLOW_MOD ACTION SET_DL_SRC and
SET_DL_DST.
Fix BUG#39: Correct misunderstanding of byte order ops for OFPAT_XXX.
We use the MKDIR_P variable that only Autoconf 2.60 and
later supports, but we were only requiring Autoconf 2.59
or later. This fixes the problem.
Also, we were not explicitly invoking AC_PROG_MKDIR_P from
configure.ac, even though we were using $(MKDIR_P). Some
other macro must have been internally invoking
AC_PROG_MKDIR_P, but it's not good to depend on that, so
this commit adds an explicit call to it.
The tests haven't been seeing much love and are suffering from bit-rot at
this point. We're removing them, since we have other ways to test at
this point.
libtool was needed when NOX was directly linking against libopenflow.
Since it doesn't do that anymore, we can drop its use (and that makes
OpenFlow configure and build slightly faster).
Because of historical string munging during the kernel build process
if you named your hardware table hwtable-something, when it was built
the filename would look appropriate, but the actual module info would change
the internal name to be hwtable_something, thus after an insmod with the filename
you could not perform an rmmod with the same filename. As a result
the naming scheme has been changed to hwtable_NAME, NAME being the hardware
the table supports.
Further, include files in the hardware table should be prefixed with the
folder name, e.g. #include "hwtable_NAME/my_header.h".
Based on commits from David Erickson <derickso@stanford.edu>.
The new build system supports using a build tree separate from the
source tree, which makes it easier to build for multiple targets
using a single source tree. It also factors out the means for specifying
the modules to be built and the source files that comprise those
modules into simple files named Modules.mk. This is intended to
make it easier to add support for separate hardware table modules in
an upcoming commit.
Make LIST_FOR_EACH[_SAFE] variable take logically correct value upon loop termination.
Also, add regression tests for linked list routines, to ensure that this
change does not break code.
Also, add new macro LIST_FOR_EACH_REVERSE.
Mikio Hara
Ben Pfaff
Justin Pettit
Ben Pfaff
casado
Martin Casado